Rohde & Schwarz ZND, Getting Started

Page: 29 / 72

Instrument tour
R&S
®
ZND
29 Getting Started 1316.2407.02 ─ 62
The USB ports can be used to connect:
●
External PC accessories such as mouse or other pointing devices, a keyboard,
printer or external storage device (USB stick, CD-ROM drive etc.).
●
External measurement equipment such as a calibration unit, power meter or switch
matrix.
4.2 Rear panel
This section gives an overview of the rear panel controls and connectors of the net-
work analyzer.
Figure 4-2: Rear Panel R&S ZND
The following connectors are available on all instruments:
●
LAN is an RJ-45 connector. Use this connector to integrate the instrument to a
Local Area Network, primarily for remote control purposes; see
Chapter 7.2.1,
"Assigning an IP address" , on page 66.
●
Connector DVI can be used to connect an external monitor; see Chapter 3.11.1,
"Connecting a monitor" , on page 21.
●
USER PORT is a 25-pin D-Sub connector used as an input and output for low-volt-
age (3.3
V) TTL control signals.
●
EXT TRIG IN and EXT TRIG OUT are two BNC connectors for 5 V TTL external
trigger signals.
●
REF OUT is a BNC output for the internal reference frequency of the R&S ZND.
Use this connector to synchronize other instruments to the analyzer.
Rear panel