Command Reference
R&S
®
ZNB/ZNBT
744
User Manual 1173.9163.02 ─ 38
Suffix:
<Chn>
.
Channel number used to identify the active trace. The effects of
marker coupling depend on the active trace number; see
<Mk>
Marker number in the range 1 to 10. This suffix is ignored
because the command affects all markers.
Parameters:
<Boolean>
ON | OFF - enables or disables marker coupling.
*RST:
OFF
Example:
Suppose that the active recall set contains two traces Trc1 and
Trc2, assigned to channels no. 1 and 2, respectively.
:CALC1:PAR:SEL 'TRC1'; :CALC1:MARK1 ON; MARK2
ON
Select Trc1 as the active trace and create the two markers no. 1
and 2. The default position for both markers is the center of the
sweep range.
CALC1:MARK:COUP ON
Create two markers no. 1 and 2 on Trc 2 and couple them to the
markers of Trc 1.
Manual operation:
See
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe]
<Boolean>
Switches the delta mode for marker
<Mk>
on trace no.
<Chn>
on or off. The marker
must be created before using
CALCulate<Chn>:MARKer<Mk>[:STATe]
. If the
active trace contains no reference marker, the command also creates a reference
marker.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk>
Marker number in the range 1 to 10.
Parameters:
<Boolean>
ON | OFF - Enables or disables the delta mode.
*RST:
OFF
Example:
Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
Create a reference marker at the center of the sweep range and
set marker 1 to delta mode.
Manual operation:
See
CALCulate<Chn>:MARKer<Mk>:FORMat
<OutFormat>
Sets/queries the output format for the (complex) value of the related marker.
SCPI Command Reference
