Rohde & Schwarz ZNB20, User Manual

Page: 1198 / 1332

Command Reference
R&S
®
ZNB/ZNBT
1183 User Manual 1173.9163.02 ─ 38
Parameters:
<TrigOutDuration> Range: 1 us (1E-6 s) to 1 s
*RST: 1 us
Default unit: s
Example: See
TRIGger:CHANnel<Ch>:AUXiliary<n>[:ENABle]
TRIGger:CHANnel<Ch>:AUXiliary<n>:INTerval <Type>
Specifies whether the trigger output pulses are sent once every measurement point or
once every sweep.
Suffix:
<Ch>
.
Channel number
<n> Auxiliary channel number. This suffix is ignored; it can be set to
1 or omitted.
Parameters:
<Type> POINt | SWEep
*RST:
SWEep
Example: See
TRIGger:CHANnel<Ch>:AUXiliary<n>[:ENABle]
TRIGger:CHANnel<Ch>:AUXiliary<n>:OPOLarity <Type>
Selects the polarity of the output trigger pulses; see Figure 7-1 .
Suffix:
<Ch>
.
Channel number
<n> Auxiliary channel number. This suffix is ignored; it can be set to
1 or omitted.
Parameters:
<Type> POSitive | NEGative
*RST:
NEGative
Example: See
TRIGger:CHANnel<Ch>:AUXiliary<n>[:ENABle]
TRIGger:CHANnel<Ch>:AUXiliary<n>:POSition <Type>
Specifies whether the trigger output signal is sent before or after data acquisition; see
Figure 7-1 . Choose this setting according to the external device to be triggered:
●
BEFore is appropriate if the the device needs to be triggered before the data is
acquired (typical example: a power meter which is used for power calibration).
●
AFTer is appropriate if the device needs to be triggered just after data acquisition
(typical example: an external generator which must be re-configured in order to get
ready for the next measurement).
Suffix:
<Ch>
.
Channel number
SCPI Command Reference