Rohde & Schwarz VSE-K149, User Manual

Page: 43 / 143

Analysis
R&S
®
VSE-K149
43 User Manual 1179.3315.02 ─ 01
Trace Mode
Defines the update mode for subsequent traces.
Clear Write Overwrite mode (default): the trace is overwritten by each measure-
ment.
Max Hold The maximum value is determined over several measurements and
displayed. The R&S
VSE saves each trace point in the trace memory
only if the new value is greater than the previous one.
Min Hold The minimum value is determined from several measurements and
displayed. The R&S
VSE saves each trace point in the trace memory
only if the new value is lower than the previous one.
Average The average is formed over several measurements.
View The current contents of the trace memory are frozen and displayed.
Blank Removes the selected trace from the display.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:MODE
on page 131
Detector
Defines the trace detector to be used for trace analysis.
Auto The detector for the respective trace is selected automatically.
Positive Peak The positive detector displays the maximum level that has been
detected during the measurement.
Negative Peak The negative peak detector displays the minimum level that has been
detected during the measurement.
Average The average detector displays the average value that has been
detected during the measurement.
RMS The RMS detector displays the RMS average value that has been
detected during the measurement.
Remote command:
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]
on page 131
5.1.2 Exporting Traces
Access : [TRACE] > "Trace Config" > "Trace / Data Export"
The functionality to export traces is similar to the Spectrum application. When you
export a trace, the R&S
VSE writes the trace data into an ASCII file. You can use the
exported data for further evaluation in other programs like a spreadsheet.
Configuring Traces