R&S
TSMX-PPS2
Using u-center Software
Getting Started 1515.7236.02 - 02
32
6.2 Connecting R&S TSMX-PPS2
If the R&S TSMX-PPS2 is powered and the device driver loaded in Windows (see
section
"Powering On / Loading USB Driver"
on page 22) it could be connected in u-
center software by selecting the emulated COM port.
Figure 6-2: Connect to the R&S TSMX-PPS2 in u-center
6.3 Configuration View
The “Configuration Message View” could be used to change the configuration for the
R&S TSMX-PPS2.
u-center:
Select menu “View”
Configuration View
Displays the list of
configuration messages…
Select the UBX message of interest in this view and press the
button to retrieve
the current configuration.
For changing any setting select the corresponding UBX message and adapt the
parameters in the message window. The new parameters will be sent to the receiver
when pressing the
button.
The following sections list some of the important configuration commands for
R&S TSMX-PPS2.
Close other software applications when using u-center
The R&S TSMX-PPS2 software interface does not allows any other software
application to interface the device at the same time.
So, be sure having closed possible connections in R&S ROMES software or
any other software application when connecting to u-center.
