Preparing for Use
R&S
®
TSME
33
User Manual 1514.6542.02 ─ 10
j)
Close the R&S
TSME Device Manager.
3. Check the IP connections in the R&S
TSME Device Manager.
All connected and switched on R&S
TSMEs should be displayed.
If not, see
2.3
Switching the Instrument On and Off
To switch on the instrument
1. Use the supplied power cable to connect the power supply to the instrument.
2. Press the On/Off key on the rear panel of the R&S
TSME.
After booting, the instrument switches to the idle mode and is ready to be accessed by
an application.
For details on instrument modes see
Chapter 6.1, "Overview of Instrument Modes"
Switching off and standby mode
When you press the On/Off key on the rear panel of the R&S
TSME to switch it off, the
instrument changes to standby mode. In standby mode, the program execution on the
instrument is stopped immediately, but the instrument is still under power connection.
Switching off during connection process
Do not switch off the instrument while a connection to the application software is being
established, otherwise the application might not be able to close properly. As a result,
the software could crash and must be shut down from the Windows Task Manager.
Removing the power supply
If you remove the power supply and reconnect it later, the behavior of the R&S
TSME
depends on the state of the instrument when the power was removed:
●
Standby mode
: the instrument returns to standby mode when power returns; must
be switched on with the On/Off key
●
Any other operational mode:
the instrument automatically boots when power
returns
Switching the Instrument On and Off
