Troubleshooting
R&S
®
TS-PMB
22
User Manual 1153.5233.12 ─ 06
Power-on test for modules with a rear I/O supply module
If the green LED indicates a problem with the supply voltage, check the LEDs of the
corresponding rear I/O supply module separately. If the LEDs on the rear I/O module
also indicate a supply voltage failure, replace the rear I/O module.
9.3
R&S
TSVP self-test
The R&S
TSVP self-test is an extensive test procedure for the whole system or individ-
ual components. After the test is done, you receive a test report for all components that
have been tested.
The self-test uses the R&S TS-PSAM module as a measurement unit. The functionality
of the modules in the system is ensured by measurements via the analog measure-
ment bus.
For more information about running the system self-test and the test procedures, refer
to the R&S
TSVP service manual.
9.4
Contacting customer support
Technical support – where and when you need it
For quick, expert help with any Rohde
&
Schwarz product, contact our customer sup-
port center. A team of highly qualified engineers provides support and works with you
to find a solution to your query on any aspect of the operation, programming or applica-
tions of Rohde
&
Schwarz products.
Contact information
Contact our customer support center at
, or follow this
QR code:
Figure 9-1: QR code to the Rohde
&
Schwarz support page
Contacting customer support
