Rohde & Schwarz SMM100A, User Manual

Page: 496 / 1088

File and data management
R&S
®
SMM100A
496 User Manual 1179.1341.02 ─ 05
Save
Saves the current instrument settings or the settings belonging to a digital standard
under the defined filename.
Remote command:
:MMEMory:STORe:STATe
on page 672
Refer to the descriptions of the firmware options for the correct syntax of the corre-
sponding SCPI commands:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:STORe
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:DELete
Save Immediate x
Stores the current instrument setting in one of the intermediate memories.
These instrument settings are retained until a different instrument setting is stored in
the intermediate memory. When the instrument is switched off, the contents of the
intermediate memories are retained.
Remote command:
*SAV
on page 657
Exclude Frequency
The current frequency is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL
on page 890
Exclude Level
The current level is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL
on page 943
Recall
Restores the selected configuration.
During recall, the instrument considers all related settings, for example sweeps in
active state or lists. An error message indicates the settings which cannot be imple-
mented.
Remote command:
:MMEMory:LOAD:STATe
on page 670
Refer to the descriptions of the firmware options for the correct syntax of the corre-
sponding SCPI command:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:LOAD
Recall Immediate x
Loads the selected configuration from one of the intermediate memories. A message
appears if no instrument configuration is stored in this memory.
Remote command:
*RCL
on page 657
Saving and recalling instrument settings