Rohde & Schwarz SMF-B1, Operating Manual, Page: 434 / 653

Remote Control Commands
R&S
®
SMF100A
419 Operating Manual 1167.2319.02 ─ 12
Example: sets the x value of reference "Point A" to -15 dBm, and the value
of "Point B" to 20 dBm.
Options: R&S SMF-K28
Manual operation: See " Define Reference - Trace Power Analysis " on page 215
:SENSe[:POWer]:SWEep:POWer:REFerence:DATA:YVALues <YValues>
Sets or queries the y values of the two reference points, i.e. "Power Y (Point A)" and
"Power Y (Point B)" in "Power" measurement.
Parameters:
<YValues> string
Example: SENSe:POW:SWE:TIME:REF:DATA:YVAL -30,10
Example: sets the y value of reference "Point A" to -30 dBm, and the value
of "Point B" to 10 dBm.
Options: R&S SMF-K28
Manual operation: See " Define Reference - Trace Power Analysis " on page 215
:SENSe[:POWer]:SWEep:POWer:RMODe <RMode>
Selects single or continuous mode for measurement mode power in power analysis.
Parameters:
<RMode> SINGle | CONTinuous
*RST:
SINGle
Example: SENS:SWE:POW:RMOD SING
selects single measurement
Options: Option R&S SMF-K28
Manual operation: See " Execution - Power Analysis " on page 220
:SENSe<ch>[:POWer]:SWEep:POWer[:SENSor]:OFFSet <Offset>
Defines the level offset at the sensor input in dB. Activate the offset with the com-
mand
:SENSe<ch>[:POWer]:SWEep:POWer[:SENSor]:OFFSet:STATe
on page 420.
Parameters:
<Offset> float
Range:
-100 to 100
Increment: 0.01
*RST:
0
Power Sensor Measurement Subsystems