Rohde & Schwarz SMCVB-K168, User Manual

Page: 49 / 91

DVB-S2 Configuration and Settings
R&S
®
SMCVB-K168
49 User Manual 1179.1064.02 ─ 03
Settings:
Network Status ..............................................................................................................49
Restart Network ............................................................................................................ 49
Hostname ......................................................................................................................49
Address Mode ............................................................................................................... 49
IP Address .....................................................................................................................50
Protocol ......................................................................................................................... 50
Subnet Mask ................................................................................................................. 50
Show Connector ............................................................................................................50
MAC Address ................................................................................................................ 50
Network Status
Indicates that the instrument is connected to the network.
If the instrument is disconnected, try "Restart Network".
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:STATus
on page 84
Restart Network
Terminates the network connection of the instrument and sets it up again later. You can
use this function to fix network problems.
Note: This function restarts only the connection of the instrument to the network. It
does not impact the network itself.
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:RESTart
on page 83
Hostname
Displays the hostname.
Displayed is the board name, that is the name of the IP data board of the
R&S
SMCV100B, e.g.
SMCV100B-123456-IP-Data
.
Each instrument is delivered with an assigned hostname, a logical name which can be
used instead of the IP address. With the default network settings, the IP address is
allocated by the DHCP server. This address can change each time the instrument is
reconnected. Unlike the IP address, the hostname name does not change.
Note:
This function is password-protected. Unlock the protection level 1 to access it.
We recommend that you do not change the default network settings or the hostname
to avoid problems with the network connection.
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:COMMon:HOSTname
on page 82
Address Mode
Selects the mode for assigning the IP address.
"Auto (DHCP)"
Assigns the IP address automatically, provided the network supports
DHCP .
"Static" Enables you to assign the IP address manually.
Local IP Data Network Settings