Instrument Function
R&S
®
SMC100A
111
Operating Manual 1411.4060.32 ─ 04
Variation Step - RF Signal
Sets the user-defined step width. This step width is used when entering the RF frequency
using the rotary knob. Frequency variation with this step width must also be activated
with "Variation Active".
SCPI command:
5.3.3 Phase Settings
The phase of the RF output signal can be changed in the "Phase Settings" section of the
"RF Frequency/Phase" menu.
5.3.3.1
Phase Menu
To open the "Frequency/Phase" menu, select "RF > Configure > Phase" or use the
MENU key under "RF".
Delta Phase - RF Signal
Sets the phase of the RF signal. The current phase of the signal is used as the reference.
This function allows, for example, the phase of the output signal to be synchronized with
the phase of a signal from a second signal generator.
SCPI command:
Reset Delta Phase Display - RF Signal
Resets delta phase value. The set phase is adopted as the new current phase, i.e. the
delta phase value is reset to 0.
SCPI command:
5.3.4 Reference Oscillator
In the internal reference mode the internal reference signal is available at the REF
OUT connector. The frequency of the internal reference signal is permanently set to 10
MHz.
The settings of the reference oscillator are not influenced by an instrument preset
("PRESET" key).
RF Signal - RF Block
