Rohde & Schwarz SMBV100B, User Manual

Page: 817 / 1030

Remote Control Commands
R&S
®
SMBV100B
815 User Manual 1178.4460.02 ─ 03
Example: See Example "Create a table with user-defined correction values
for the RF level" on page 811 .
Usage: Query only
Manual operation: See "User Correction" on page 385
[:SOURce<hw>]:CORRection:ZERoing:STATe <State>
Activates the zeroing procedure before filling the user correction data acquired by a
sensor.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
1
Example: See Example "Fill user correction data with sensor"
on page 812.
Manual operation: See " Fill User Correction Data with Sensor" on page 389
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
Fills the selected user correction list with the level values measured by the power sen-
sor for the given frequencies.
Suffix:
SENSor<ch>
.
Defines the used power sensor, i.e. the sensor whose values are
used.
Example: See Example "Fill user correction data with sensor"
on page 812.
Usage: Event
[:SOURce<hw>]:CORRection[:STATe] <State>
Activates user correction with the currently selected table.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: See Example "Create a table with user-defined correction values
for the RF level" on page 811 .
Manual operation: See "State" on page 385
[:SOURce]:CORRection:CSET:CATalog?
Queries a list of available user correction tables.
SOURce Subsystem