Rohde & Schwarz SMBV100B, User Manual

Page: 655 / 1030

Remote Control Commands
R&S
®
SMBV100B
653 User Manual 1178.4460.02 ─ 03
:SLISt:ELEMent<ch>:MAPPing <Mapping>
Assigns an entry from the
:SLISt[:LIST]?
to one of the four sensor channels.
Parameters:
<Mapping> SENS1 | SENSor1 | SENS2 | SENSor2 | SENS3 | SENSor3 |
SENS4 | SENSor4 | UNMapped
Sensor channel.
*RST:
UNMapped
Example: See Example "Detecting and assigning a power sensor"
on page 650.
Manual operation: See " Sensor Mapping List " on page 395
:SLISt:SENSor:MAP <SensorId>, <Mapping>
Assigns a sensor directly to one of the sensor channels, using the sensor name and
serial number.
To find out the the sensor name and ID, you can get it from the label of the R&S NRP,
or using the command
:SLISt:SCAN[:STATe]
. This command detects all R&S NRP
power sensors connected in the LAN or via 'USBTMC protocol.
Setting parameters:
<SensorId> string
<Mapping> enum
Example: See Example "Detecting and assigning a power sensor"
on page 650.
Usage: Setting only
Manual operation: See " Sensor Mapping List " on page 395
:INITiate<hw>[:POWer]:CONTinuous <Continuous>
Switches the local state of the continuous power measurement by R&S NRP power
sensors on and off. Switching off local state enhances the measurement performance
during remote control.
The remote measurement is triggered with
:READ<ch>[:POWer]?
). This command
also returns the measurement results. The local state is not affected, measurement
results can be retrieved with local state on or off.
Parameters:
<Continuous> 0 | 1 | OFF | ON
*RST:
0
Example: INIT1:CONT ON
Switches local state of continuous power measurement on.
Manual operation: See " State " on page 399
SENSe, READ, INITiate and SLISt Subsystems