Rohde & Schwarz SMBV100B, User Manual

Page: 303 / 1030

Configuring the RF Signal
R&S
®
SMBV100B
301 User Manual 1178.4460.02 ─ 03
1 GHz/1 to 100 MHz at connector Ref In 1 GHz/Ref In and 10 MHz at Ref Out
●
E.g., External Ref. f
ref
= 100 MHz
●
Source = "External"
●
External Reference Frequency = "100 MHz"
●
Reference Output/1GHz Reference Output = "10 MHz"
●
Synchronization Bandwidth = "Narrow"
6.8.3 Reference Frequency Settings
Access:
1. Select one of the following:
● "RF" > "Reference Frequency"
● "System Config" > "Setup" > "General" > "Reference Frequency"
In the "Reference Frequency" tab, you can select the signal source of the reference
frequency and define the frequency of an external reference signal.
2. Observe the information in the status bar of the block diagram.
The status bar indicates the current oscillator configuration.
The remote commands required to define these settings are described in Chap-
ter 12.16.16, "SOURce:ROSCillator Subsystem" , on page 876.
Settings:
Set to Default .............................................................................................................. 302
Source .........................................................................................................................302
Show Connector ..........................................................................................................302
Deactivate RF Output (if external reference is missing) ..............................................302
External Reference Frequency ................................................................................... 302
Variable Reference Frequency ....................................................................................303
Reference Oscillator