Rohde & Schwarz SMBV100B, User Manual

Page: 155 / 1030

Configuring the Internal Baseband Source
R&S
®
SMBV100B
153 User Manual 1178.4460.02 ─ 03
The waveform files are files with predefined file extension
*.wv
. When a file is
selected, the dialog displays short information about the selected waveform.
Enable the ARB generator ("ARB > State > On") to trigger the instrument to load and
process the selected waveform file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WAVeform:SELect
on page 750
Waveform Info
Opens a dialog with detailed information about the currently selected waveform. The
display depends on whether the selected waveform file is a multi-segment one or not.
All parameters are read-only.
Remote command:
For non-multi segment waveform files, use the
Tag
commands (see Chapter 3.6.5,
"Tags for Waveforms, Data and Control Lists" , on page 177).
Clock Frequency
Displays or sets the ARB output clock rate.
The value of this parameter is set to the clock rate defined in the loaded waveform file
(
{CLOCK}
tag). The value can be changed afterwards.
Note: The clock frequency must match the value of the externally applied clock source.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CLOCk
on page 753
Create Multi Segment
Accesses the dialog for creating multi-segment waveforms (see Chapter 3.7, "Generat-
ing Multi-Segment Waveform Files" , on page 193).
Using the Arbitrary Waveform Generator (ARB)