Rohde & Schwarz SMBV100A, Operating Manual

Page: 533 / 911

Remote Control Commands
R&S
®
SMBV100A
518 Operating Manual 1176.8016.02 ─ 17
{SAMPLES: Samples}
(recommended for waveforms)
The tag contains the number of I/Q samples in the waveform in ASCII format.
On multi-segment waveforms, this tag contains the total I/Q samples of all segments.
Example: {SAMPLES: 1000}
BB:ARB:WAV:TAG? 'SAMPLES'
Queries the content of the
SAMPLES
tag of the selected wave-
form file.
Response: 1000
The waveform contains 1000 I/Q samples.
Usage: Setting only
See also Chapter 7.4.2, "How to Define Periodically Repeating Traces" ,
on page 524.
{[TRACE] LIST [#]: Pos0:State0; Pos1:State1; ...PosN-1:StateN-1}
(mandatory for control lists / optional for waveforms)
The tag contains the data for the marker and control signals in the control list or the
marker signals of ARB waveforms.
Traces are processed different, depending on the selected CONTROL LENGTH .
See also Chapter 7.4.2, "How to Define Periodically Repeating Traces" ,
on page 524.
Setting parameters:
[TRACE] MARKER | BURST | LEVATT | CW MODE | HOP | MAP
Name of the marker or control signal.
For ARB waveforms, it is only meaningful to define marker sig-
nals; in the ARB multi-segment waveforms these tags are
ignored!
[#] 1 .. 4
Sets the marker or control trace number; supported is only
LEVATT LIST 1.
Pos Specifies in ASCII format the position (i.e. sample number or
data value), with effect from which the binary
State
of the
marker or of the control signal changes.
State 0 | 1
Specifies the binary state of the marker or of the control signal
from
Pos
x
to
Pos
x+1
exclusive in ASCII format.
Waveform and List Format