Remote Control Commands
R&S
®
SMBV100A
602
Operating Manual 1407.6062.32 ─ 08
Example:
SOURBB:MCCW:SEQ SING
sets trigger mode Single.
SOURBB:MCCW:TRIG:SLEN 200
sets a sequence length of 200 samples. The first 200 samples of
the current waveform will be output after the next trigger event.
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce
<Source>
The command selects the trigger source.
Parameters:
<Source>
INTernal | EXTernal | BEXTernal | OBASeband
INTernal
Triggering is executed by means of the Trigger command
BB:MCCW:TRIG:EXECute
in the case of remote control, and by
means of "Execute Trigger" in the case of manual operation.
EXTernal
Triggering is executed by means of the signal on the TRIGGER 1
connector.
*RST:
INT
Example:
BB:MCCW:TRIG:SOUR INT
sets internal triggering.
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay
<Delay>
The command specifies the trigger delay (expressed as a number of samples)for external
triggering.
Parameters:
<Delay>
float
Range:
0 to 65535
Increment: 0.01
*RST:
0
Example:
BB:MCCW:TRIG:SOUR EXT
selects an external trigger via the TRIGGER 1 connector
BB:MCCW:TRIG:DEL 200
sets a delay of 200 samples for the trigger.
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit
<Inhibit>
The command specifies the number of samples by which a restart is to be inhibited fol-
lowing a trigger event. This command applies only in the case of external triggering.
Parameters:
<Inhibit>
integer
Range:
0 to 67108863
Increment: 1
*RST:
0
SOURce Subsystem
Summary of Contents for SMBV100A
Page 31: ......
