Remote Control Commands
R&S
®
SMBV100A
553
Operating Manual 1407.6062.32 ─ 08
Example:
BB:DM:CLOC:MODE SYMB
selects clock type Symbols, i.e. the supplied clock is a symbol
clock.
[:SOURce<hw>]:BB:DM:CLOCk:MULTiplier
<Multiplier>
The command specifies the multiplier for clock type
Multiple Symbols
(
BB:DM:CLOCk:MODE MSYM
) in the case of an external clock source.
Parameters:
<Multiplier>
float
Range:
1 to 64
Increment: 1
*RST:
4
Example:
BB:DM:CLOC:SOUR EXT
selects the external clock source. The clock is supplied via the
CLOCK connector.
BB:DM:CLOC:MODE MSYM
selects clock type Multiple Symbols, i.e. the supplied clock has a
rate which is a multiple of the symbol rate.
BB:DM:CLOC:MULT 12
the multiplier for the external clock rate is 12.
[:SOURce<hw>]:BB:DM:CLOCk:SOURce
<Source>
The command selects the source for the digital modulation clock.
Parameters:
<Source>
INTernal | EXTernal
INTernal
The internal clock reference is used.
EXTernal
The external clock reference is supplied to the CLOCK connector.
*RST:
INTernal
Example:
BB:DM:CLOC:SOUR INT
selects the internal clock reference.
[:SOURce<hw>]:BB:DM:CLOCk:SYNChronization:MODE
<Mode>
Selects the synchronization mode
This parameter is used to enable generation of very precise synchronous signal of several
connected R&S SMBVs.
Note
: If several instruments are connected, the connecting cables from the master instru-
ment to the slave one and between each two consecutive slave instruments must have
the same length and type. Avoid unnecessary cable length and branching points.
SOURce Subsystem
Summary of Contents for SMBV100A
Page 31: ......
