Rohde & Schwarz Smart Instruments UP300, Operating Manual

Page: 311 / 355

R&S UP300/350 Graph Menu
Operating Manual, 11/2007 6-311 E-1147.2759.00
6.4.4.2.2 Manual Positioning the Y Cursors
Use If you have activated the Y cursor, you can move it manually on the trace
using the cursor keys (applies only to the full-screen display,
Ê 6-314), or the rotary knob. You can also enter a specific value if you want
to set the cursor at precise position. The user can control only the cursor
selected in the graph menu (X1, X2). To move the cursor, use the rotary
knob.
Manual
positioning the
Y cursors 1. Activate the Y cursor ( Ê 6-310).
2. Press the function key in the Y cursor submenu .
An entry field containing the currently applicable setting is displayed.
3. a) Enter a new value ( Ê 5-65).
The permissible entry range is:
MIN
≤
CURSOR POSITION
≤
MAX
within: MIN - lower limit of the display range (
Ê
6-297)
MAX - upper limit of the display range ( Ê 6-297)
b) Use the rotary knob
[11] to select a setting.
The new position is displayed in the measurement diagram.
Note: The cursor parameters are shown in the full-screen display ( Ê 6-314).