Rohde & Schwarz Smart Instruments UP300, Operating Manual

Page: 224 / 355

Analyzer R&S UP300/350
E-1147.2759.00 6-224 Operating Manual, 11/2007
6.3.2 Setting the Measurement Functions (FUNCTIONS)
Description In the FUNCTIONS menu, you can select the analyzer functions which you
want to activate and configure. The selected measurement function is
displayed in a vacant field in the menu bar and is available as a menu key to
allow you to enter parameters for the measurement function. At the same
time, the appropriate measurement function is activated in the analyzer.
You can only activate a limited number of measurement functions. All
functions which can no longer be combined with the already selected
measurement functions are deactivated (displayed in gray).
When you have selected a measurement function in the menu bar, the list of
available measurement parameters appears on the screen (
Ê 6-226).
Selecting the
FUNCTIONS menu
Select the menu with the
3 or 4
cursor keys .
The menu name is highlighted and the function keys [13] are assigned
the appropriate function.
The 1
st
function key
assignment
Display the next set of functions.
Measure the frequency, DC voltage, and RMS. ( Ê 6-228)
Measure the peak value. (
Ê
6-237)
Measure the quasi-peak value. ( Ê 6-243)
Selective RMS measurement ( Ê 6-246)
Frequency-domain display mode of the input signal ( Ê 6-251)
Measure distortion (THD, THD+N, SINAD, Noise). ( Ê 6-259)