R&S UP300/350
Generator
Operating Manual, 11/2007
6-211
E-1147.2759.00
Selecting the Signal Source
Use
You can monitor signals at the audio monitoring output [15] using
headphones. You can select the following signal sources:
Anl. Filter
Analyzer signal downstream of the filter stage
Generator
Generator output signal
Note:
The setting is always valid for both channels (Ch 1&2).
Selecting the
signal source
1.
Press the
function key
in the
menu.
A selection field containing the available settings is displayed. The
default setting is “” “Generator“.
2.
Use the
rotary knob
[11] to select a setting.
3.
Press the
ENTER key
[5] to close the selection field.
The new setting is stored and displayed in the parameter field.
Setting the Volume
Use
You can enter the volume of the signal at the audio monitoring output. The
setting is in percent and refers to the corresponding signal level.
Selecting
the channel
1.
Press the numeric keys
1
,
2
, or
3
to select channel
Ch 1
,
Ch 2
, or both
channels
Ch 1&2
.
The selected channel is displayed in green in the channel display.
Entering
the volume
2.
Press the
function key
in the
menu.
An entry field containing the currently applicable setting is displayed. The
default setting is “20 %“.
3.
Enter a new value (
Ê
The permissible entry range is:
0 %
≤
VOLUME
≤
100 %
The new setting is stored and displayed in the parameter field.
Ch 1
Ch 2
Ch 1&2
Summary of Contents for Smart Instruments UP300
Page 1: ...11 2007...
Page 20: ...R S UP300 350 E 1147 2759 00 1 20 Operating Manual 11 2007...
Page 30: ......
