R&S UP300/350
Generator
Operating Manual, 11/2007
6-165
E-1147.2759.00
Entering the Amplitude Range
Use
To set the amplitude range, enter the
and
values of the
amplitude sweep.
Entering the
start value
1.
Press the
function key
in the
submenu
.
An entry field containing the currently applicable setting is displayed. The
default setting is “100 mV (0.1 FS)”. At the same time, the function keys
[13] are assigned various units of measurement.
Analog
Digital
2.
Enter a new value (
Ê
The permissible entry range is:
1 µV
≤
Start
≤
V
Stop
(Analog)
0.0001 FS
≤
Start
≤
V
Stop
(Digital)
-140 dBFS
≤
Start
≤
V
Stop
(Digital)
within: V
Stop
- stop value of amplitude sweep (
Ê
below)
The new setting is stored and displayed in the parameter field.
Analog
Digital
Entering the
stop value
3.
Press the
function key
in the
submenu
.
An entry field containing the currently applicable setting is displayed. The
default setting is “7.495 V (0.9999 FS)”. At the same time, the function
keys are assigned various units of measurement.
Summary of Contents for Smart Instruments UP300
Page 1: ...11 2007...
Page 20: ...R S UP300 350 E 1147 2759 00 1 20 Operating Manual 11 2007...
Page 30: ......
