Rohde & Schwarz Scope Rider RTH1002, User Manual, Page: 100 / 530

Waveform Analysis
R&S
®
Scope Rider RTH
100 User Manual 1326.1578.02 ─ 12
Remote command:
●
CHANnel<m>:HISTory:PLAY
on page 346
●
CHANnel<m>:HISTory:REPLay
on page 347
●
CHANnel<m>:HISTory:CURRent
on page 346
4.7.3 Analyzing History Data
You can analyze the stored segments using the following possibilities:
●
Switch analog channels on and off if they were active during acquisition.
●
Change vertical scale and position of captured channels.
●
Use the zoom.
●
Save screenshots.
●
Use cursor measurements.
●
Use automatic measurements.
●
Use the mathematical functions.
●
Switch logic channels on and off if at least one channel was active during acquisi-
tion.
●
Enable and disable the serial bus if it was active during acquisition.
4.7.4 Exporting History Data
You can export history data to files. History data is always saved in "Compressed CSV"
files. Each segment is saved to a separate file, and all segment files are written to a
compressed folder.
Figure 4-5: Content of a history waveform folder
The filenames of the segment files are built using the filename pattern and the seg-
ment index:
<filename base>_<date>_<segment-timestamp>_<index>.csv
.
The filename of the ZIP file uses the same scheme and the timestamp of the oldest
segment. Timestamps in filenames are always absolute time.
History (Option R&S RTH-K15)