Measurements
R&S
®
RTM20xx
97
User Manual 1317.4726.02 ─ 01
Reference Level: Upper, Middle, Lower Levels
Set the lower and upper reference levels for rise and fall time mesurements (cursor and
automatic mesurements) as well as the middle reference level used for phase and delay
measurements. The levels are defined as percentages of the high signal level. The set-
tings are valid for all measurement places.
Remote command:
Clear All
Resets and deactivates all four measurements.
Remote command:
Delay Setup
Configures the delay measurement that measures the time difference between two edges
of the same or different waveforms.
"Source 1,
Source 2"
Select one of the active channel, math or reference waveforms for each
measurement source.
"Slope"
Select the rising or falling slope for each measurement source.
Remote command:
Phase Setup
Configures the phase measurement that measures the pahse difference between two
waveforms.
"Source 1,
Source 2"
Select one of the active channel, math or reference waveforms for each
measurement source.
Remote command:
Automatic Measurements
