Installation
System Setup
3-2
VENICE 2U | Hardware Guide | Version 1.2
Rohde & Schwarz DVS GmbH
3.1 System
Setup
To install the hardware of VENICE 2U perform the following:
1.
Unpack the R&S DVS system and its accessories.
2.
Place the R&S DVS system on a firm, flat surface within reach of a
power outlet or mount it in a rack. For good air circulation and
cooling make sure the ventilation holes are not covered.
3.
Connect at least the following computer peripherals:
Mouse,
keyboard and
a monitor that is operable at a resolution of at least
1280 × 1024 pixels (default manufacturing setting).
4.
Connect any other peripheral computer and video equipment. For
an overview of the panels and connectors at the system’s rear see
section “Overview of the Rear” on page 2-13.
5.
Connect the power cable(s) to the system.
The VENICE 2U hardware is now properly installed and you can switch
on the system as described in section “Starting the System” on
page 4-2.
Check your delivery and compare it with the delivery note included in
the package on an extra sheet of paper. In case of missing items, please
contact your local vendor or R&S DVS immediately.
Incorrect packaging
The warranty will be void if you do not transport the R&S DVS de-
vice in the original packing.
You have to keep the original packing and use it in case of a
return transportation.
After installing the hardware the R&S DVS system has to be set up first
before it can be used. How to perform the initial setup is described in
detail in the software documentation delivered with the system.