Rohde & Schwarz R&S UPP, User Manual

Page: 853 / 938

Remote Control - Command Description
R&S
®
UPP
837 User Manual 1411.1055.32 ─ 10
Parameters:
<integer> 0...32767
STATus:OPERation:EVENt?
The command queries the content of the
EVENt
part of the
STATus:OPERation
reg-
ister. This part contains the information about the current instrument state since the last
readout.
A bit set in the
EVENt
register indicates a change of the corresponding bit in the
CONDition
register. Whether bits in the
EVENt
register are set due to a bit transition
from 0 to 1 or from 1 to 0 depends on the bits set in the
PTRansition
and the
NTRansition
registers.
Reading the information clears the register.
Return values:
<argument> integer
Usage: Query only
STATus:OPERation:NTRansition <integer>
The command sets the bits of the
NTRansition
part of the
STATus:OPERation
reg-
ister. A bit set in the
NTRansition
register causes a bit transition from 1 to 0 in the
CONDition
register to produce an entry in the
EVENt
register.
Reading the information does not clear the register.
Parameters:
<integer> 0...32767
STATus:OPERation:PTRansition <integer>
The command sets the bits of the
PTRansition
part of the
STATus:OPERation
reg-
ister. A bit set in the
PTRansition
register causes a bit transition from 0 to 1 in the
CONDition
register to produce an entry in the
EVENt
register. Reading the informa-
tion does not clear the register.
Parameters:
<integer> 0...32767
STATus:QUEStionable:CONDition?
The command queries the content of the
CONDition
part of the
STATus:QUEStionable
register. This part contains the information about the current
instrument state.
Reading the information does not clear the register.
Return values:
<argument> integer
STATus Subsystem