Rohde & Schwarz R&S UPP, User Manual

Page: 852 / 938

Remote Control - Command Description
R&S
®
UPP
836 User Manual 1411.1055.32 ─ 10
●
STATus:QUEStionable:UNDerrange:EVENt?
on page 839
●
STATus:QUEStionable:UNDerrange:NTRansition
on page 839
●
STATus:QUEStionable:UNDerrange:PTRansition
on page 840
●
STATus:QUEue:NEXT?
on page 844
●
STATus:XQUEstionabl:CONDition?
on page 842
●
STATus:XQUEstionabl:ENABle
on page 843
●
STATus:XQUEstionabl:EVENt?
on page 843
●
STATus:XQUEstionabl:NTRansition
on page 843
●
STATus:XQUEstionabl:PTRansition
on page 843
STATus:PRESet
The command resets the status registers.
STATus:OPERation
STATus:QUEStionable
STATus:XQUEstionable
All PTRansition parts are set to 7FFFh (32767), i.e.
all transitions from 0 to 1 are detected.
STATus:QUEStionable:UNDERrange
STATus:QUEStionable:OVERrange
STATus:QUEStionable:MEASuring
All PTRansition parts are set to FFFFh (65535) , i.e.
all transitions from 0 to 1 are detected.
The NTRansition parts of all status registers are set to 0, i.e. a transition from 1 to 0 of
a CONDition bit is not detected. The ENABle parts of all status registers are set to 0,
i.e. none of the events in these registers is passed on.
The command triggers an event and therefore has no query form and no *RST value.
STATus:OPERation:CONDition?
The command queries the content of the
CONDition
part of the
STATus:OPERation
register.
This part contains the information about the current instrument state.
Reading the information does not clear the register.
Return values:
<argument> integer
Usage: Query only
STATus:OPERation:ENABle <integer>
The command sets the bits of the
ENABle
part of the
STATus:OPERation
register.
This setting determines which events of the
EVENt
part of the
STATus:OPERation
register are to be passed on to the summary bit of the status byte. These events can
be used to trigger a service request.
STATus Subsystem