Rohde & Schwarz R&S UPP, User Manual

Page: 838 / 938

Remote Control - Command Description
R&S
®
UPP
822 User Manual 1411.1055.32 ─ 10
Cursor
Set O cursor | Set X cursor,
Marker B
Parameters:
<state> ONCE | EXEC | OFF
DISPlay:FFT<n2>:OCURsor:SETTo:XPOS <xpos>
DISPlay:FFT<n2>:XCURsor:SETTo:XPOS <xpos>
DISPlay:WAVeform<n2>:OCURsor:SETTo:XPOS <xpos>
DISPlay:WAVeform<n2>:XCURsor:SETTo:XPOS <xpos>
DISPlay:BARGraph<n2>:OCURsor:SETTo:XPOS <xpos>
DISPlay:BARGraph<n2>:XCURsor:SETTo:XPOS <xpos>
DISPlay:SWEep<n2>:OCURsor:SETTo:XPOS <xpos>
DISPlay:SWEep<n2>:XCURsor:SETTo:XPOS <xpos>
Corresponds to softkey operation:
Cursor
Set O cursor | Set X cursor,
Value
Parameters:
<xpos> float
Sets O cursor | X cursor to the defined value if a vertical cursor
is involved.
The unit in which the value is entered depends on the unit of the
X-axis.
Example: DISPlay:WAVeform:OCURsor:SETTo:XPOS 12.345 Hz
DISPlay:FFT<n2>:OCURsor:SETTo:YPOS <ypos>
DISPlay:FFT<n2>:XCURsor:SETTo:YPOS <ypos>
DISPlay:WAVeform<n2>:OCURsor:SETTo:YPOS <ypos>
DISPlay:WAVeform<n2>:XCURsor:SETTo:YPOS <ypos>
DISPlay:BARGraph<n2>:OCURsor:SETTo:YPOS <ypos>
DISPlay:BARGraph<n2>:XCURsor:SETTo:YPOS <ypos>
DISPlay:SWEep<n2>:OCURsor:SETTo:YPOS <ypos>
DISPlay:SWEep<n2>:XCURsor:SETTo:YPOS <ypos>
Corresponds to the softkey operation:
Cursor
Set O cursor | Set X cursor,
Value
Softkey Commands of the Graphical Display