Rohde & Schwarz R&S UPP, User Manual

Page: 818 / 938

Remote Control - Command Description
R&S
®
UPP
802 User Manual 1411.1055.32 ─ 10
DISPlay:FFT<n2>:X:REFerence:VALue <value>
DISPlay:WAVeform<n2>:X:REFerence:VALue <value>
DISPlay:SWEep<n2>:X:REFerence:VALue <value>
Parameters:
<value> float
Manual operation: See "Ref Value " on page 550
DISPlay:FFT<n2>:X:RIGHt <right>
DISPlay:WAVeform<n2>:X:RIGHt <right>
DISPlay:SWEep<n2>:X:RIGHt <right>
Parameters:
<right> float
Manual operation: See "Right" on page 551
DISPlay:FFT<n2>:X:SCALing <scaling>
DISPlay:WAVeform<n2>:X:SCALing <scaling>
DISPlay:SWEep<n2>:X:SCALing <scaling>
Parameters:
<scaling> AUTO | MANual
Manual operation: See "Scaling" on page 550
DISPlay:SWEep<n2>:X:SOURce <source>
Parameters:
<source> SWEep | HOLD | MANual | LRMS | LDC | LPEak | FREQuency
Manual operation: See "X-Source" on page 544
DISPlay:FFT<n2>:X:SPACing <spacing>
DISPlay:WAVeform<n2>:X:SPACing <spacing>
DISPlay:SWEep<n2>:X:SPACing <spacing>
Parameters:
<spacing> LINear | LOGarithmic
Manual operation: See "Spacing" on page 551
DISPlay:FFT<n2>:X:UNIT <unit>
DISPlay:WAVeform<n2>:X:UNIT <unit>
DISPlay:SWEep<n2>:X:UNIT <unit>
It is recommended to use the command recording in order to find the correct unit
parameter, see
Chapter 6.7, "Command Recording" , on page 661 .
Parameters:
<unit> string
Traces, Spectrum Displays and Bargraphs