Rohde & Schwarz R&S UPP, User Manual

Page: 701 / 938

Remote Control - Command Description
R&S
®
UPP
685 User Manual 1411.1055.32 ─ 10
●
*RST
on page 687
●
*SRE
on page 687
●
*STB?
on page 687
●
*TRG
on page 687
●
*WAI
on page 688
*CLS
CLEAR STATUS sets the status byte (STB), the standard event register (ESR) and the
EVENt part of all QUEStionable and the OPERation register to zero. The command
does not alter the mask and transition parts of the registers. It clears the output buffer.
In order to start a remote control program with a defined initial device status use com-
mand
*RST
or
SYSTem:PRESet
to preset the instrument. Then use command
*CLS
to
clear the ESR Event status register e.g. in case of an aborted synchronization.
*ESE <Value>
EVENT STATUS ENABLE sets the event status enable register to the value indicated.
The query form *ESE? returns the contents of the event status enable register in deci-
mal form.
Parameters:
<Value> 0 to 255
*ESR? <Value>
STANDARD EVENT STATUS QUERY returns the contents of the event status register
in decimal form (0 to 255) and subsequently sets the register to zero.
Parameters:
<Value> 0 to 255
Usage: Query only
*GTL
Go To Local ends remote control and returns to manual control.
Usage: Event
*IDN?
IDENTIFICATION QUERY queries the instrument identification. The instrument type,
order and serial number and the firmware version are returned.
Common Commands