Rohde & Schwarz R&S UPP, User Manual

Page: 544 / 938

Instrument Functions
R&S
®
UPP
528 User Manual 1411.1055.32 ─ 10
The "Normalize" parameter field is hidden if you select the function measurement
result with Funct Ch1 | Funct Ch2 | Function under Y-source and if an intermodulation
measurement is set in the analyzer function panel. Intermodulation measurement
results are measurement results that have already been referenced and cannot be ref-
erenced again.
Available in the graphics subsystems
Sweep, FFT, Bar Graph
"OFF" Normalization is deactivated.
"Value " Fixed normalization value which is entered as a multiplication factor
or a dB value in the parameter field below.
"O Cursor" The trace is normalized once only at the o cursor to 0 dBr or V/Vr =
1. For this purpose, the referenced trace value is read out and the
reciprocal value is entered in the parameter field below. The parame-
ter then changes back to VALUE.
"X-Cursor" As for the o cursor.
Remote command:
DISPlay:SWEep<n2>:A:NORMalize
on page 794
DISPlay:SWEep<n2>:B:NORMalize
on page 794
Normalize Value
Used to enter a fixed normalization value as a factor. This value applies to all scans.
Available in the graphics subsystems
Sweep, FFT, Bar Graph
Remote command:
DISPlay:SWEep<n2>:A:NORMalize:VALue
on page 795
DISPlay:SWEep<n2>:B:NORMalize:VALue
on page 795
Unit Fnct Track
Used to determine whether the unit is the same as that set in the analyzer or whether it
can be user-selected. This parameter field is displayed only for graphics systems that
are referenced to the measurement function in the analyzer and whose display unit can
be set in the corresponding Config panel.
Curve, Spectrum and Bar Graph Display