Rohde & Schwarz R&S UPP, User Manual

Page: 505 / 938

Instrument Functions
R&S
®
UPP
489 User Manual 1411.1055.32 ─ 10
Remote command:
AUXiliaries:TRIGger:OUTPut:MODE
on page 778
AUXiliaries:TRIGger:OUTPut:DELay
on page 778
5.44 Switcher Panel
This section describes how to connect and operate the R&S UPZ switcher on the
R&S UPP.
5.44.1 Connecting Switcher to R&S UPP
The R&S UPZ audio switchers can be connected to the R&S UPP.
The new R&S UPZ models .12 and .13 have a USB interface and can be connected to
the R&S UPP directly using a USB cable. The older R&S UPZ models .02/.03 that do
have a RS232 interface but no USB interface can be connected to the R&S UPP using
a conventional USB to serial adapter.
The required driver has to be installed before initial startup. The description for the
driver installation can be found in the operating manual for the R&S
UPZ Audio
Switcher, Chapter "Startup", "Installation of USB driver".
The R&S UPZ may be used as an input switcher or an output switcher. An input
switcher makes it possible to connect up to eight different DUTs to the two analyzer
inputs without having to change connectors each time. An output switcher can supply
up to eight DUTs with the generator channels delivered by the R&S
UPP.
Up to 16 input switchers and 16 output switchers can be connected to the R&S UPP,
making up to 128 channels available.
The two busbar connectors A and B on the front panel of the R&S UPZ have to be con-
nected to the R&S UPP. In the case of an input switcher the XLR connectors on the
busbar are connected to the analyzer inputs, and in the case of an output switcher the
XLR connectors on the busbar are connected to the generator outputs.
The R&S UPZ is controlled via the COM interface of the R&S UPP.
Switcher Panel