Rohde & Schwarz R&S UPP, User Manual

Page: 355 / 938

Instrument Functions
R&S
®
UPP
339 User Manual 1411.1055.32 ─ 10
Table 5-2: The following states are possible:
Off Channel is deactivated; measured values are not recorded on this channel.
Single Single measurement in progress
Cont Continuous measurement is being performed
Terminated (Single) measurement terminated
Stopped Measurement has been terminated; continuous measurement has been paused.
Further messages about the states of a current measurement, e.g. underrange or over-
range information, can also be displayed. For more detailed information, see
Chap-
ter 4.20, "Overview of Status Messages" , on page 193.
5.15.3.1 Continuous measurement
This is the standard operating mode of the measurement system, and it is set each
time the R&S
UPP is switched on. The R&S UPP measures all activated measure-
ment types continuously until one of the following events occurs:
START
[START ] terminates the current measurement immediately, resets the MIN/MAX indi-
cator, the MIN/MAX values, the limit violations of the measurement displays, and cau-
ses continuous measurement to be restarted.
Furthermore, starting or restarting a measurement also causes certain generator func-
tions to restart:
●
The sine-burst burst signal is reset, that is, it starts with the burst phase or burst on
delay.
●
The Play function starts again at the first sample in the WAV file.
●
The Arbitrary function also starts again at the beginning.
Remote command:
INITiate:CONTinuous
on page 731
SINGLE
[SINGLE ] switches to single measurement. Each measurement type first completes
the measurement that has already been started; when all measurement types have
been completed, the measurement system is in the "Term" (terminated) state. Continu-
ous measurement can be reactivated by pressing [START] or [STOP/CONT].
Starting Measurements