Rohde & Schwarz R&S UPP, User Manual

Page: 349 / 938

Instrument Functions
R&S
®
UPP
333 User Manual 1411.1055.32 ─ 10
Remote command:
SENSe[1]:REFerence:CHANnel
on page 723
Trigger Chan
Used to select the channel whose event triggers a measurement.
If a measuring channel which was inactive is selected as a trigger channel, it is auto-
matically switched on.
If the channel selected as a trigger channel is switched off, a warning appears. Upon
confirming it, the trigger channel is set the same as the reference channel.
Chap-
ter 5.16, "Start Conditions" , on page 342.
Remote command:
TRIGger:CHANnel
on page 734
Start Cond
Specifies the event which triggers a measurement.
Depending on the "Start Cond" selected, the measurement either begins immediately
(Auto) or only when the desired trigger condition is fulfilled; for details see
Chap-
ter 5.16, "Start Conditions" , on page 342.
Remote command:
TRIGger:SOURce
on page 734
Delay
Delay for Start Cond.
You can enter a delay for the "Start Cond Auto" menu item. For details, see Chap-
ter 5.16, "Start Conditions" , on page 342.
Remote command:
TRIGger:DELay
on page 734
Configuring the HDMI Analyzer