Rohde & Schwarz R&S UPP, User Manual

Page: 329 / 938

Instrument Functions
R&S
®
UPP
313 User Manual 1411.1055.32 ─ 10
"Auto" The sampling rate is measured, set and displayed in the following
line. If the applied sampling rate is changed the set value is automati-
cally updated.
Note: The digital analyzer must re-initialized for each new sampling
frequency. To avoid the need to repeat this time-consuming proce-
dure too often, minor deviations and fluctuations (below 3
Hz) are
ignored.
"32 kHz to
192 kHz" Standard sampling rate 32 kHz to 192 kHz
"Value " Variable input of sampling rate
Remote command:
INPut[1]:SAMPle:FREQuency:MODE
on page 725
INPut[1]:SAMPle:FREQuency
on page 725
Pre Filter
The selected prefilter affects all measurement functions. This permits desired prefilter-
ing without selecting appropriate filters for the individual measuring functions.
Remote command:
INPut[1]:FILTer
on page 773
Input
Selection of the input interface for the Digital Audio Analyzer with the R&S UPP-B2
(digital audio interfaces) option
"Unbal (BNC)" Unbalanced digital audio input at the BNC socket
"Optical" Optical digital audio input (TOSLINK).
"Bal (D-Sub)" Balanced digital audio input at the D-Sub male connector on the front
panel
"Intern" Internal connection to the Digital Audio Generator
Loop measurement possible without connected cable.
Remote command:
INPut[1]:TYPE
on page 725
Start Cond
Specifies the event which triggers a measurement.
Configuring the Digital Analyzer