Rohde & Schwarz R&S UPP, User Manual

Page: 326 / 938

Instrument Functions
R&S
®
UPP
310 User Manual 1411.1055.32 ─ 10
If a measurement channel which was inactive is selected as a trigger channel it is auto-
matically switched on. A warning appears if the channel selected as a trigger channel
is switched off.
Switching off the measuring channel, which was selected as the trigger channel, there-
fore changes the trigger channel after this warning has been acknowledged.
Remote command:
TRIGger:CHANnel
on page 734
Start Cond
Specifies the event which triggers a measurement.
Depending on the "Start Cond" selected, the measurement starts either immediately
(Auto) or only once the required trigger condition is met; For details, see
Chapter 5.16,
"Start Conditions" , on page 342.
Remote command:
TRIGger:SOURce
on page 734
Delay
Delay for Start Cond.
You can enter a delay for the menu item "Start Cond Auto". For details, see Chap-
ter 5.16, "Start Conditions" , on page 342.
Remote command:
TRIGger:DELay
on page 734
Max FFT Size
Used to limit automatic zoom fitting for the FFT size for all FFT-supported measure-
ment functions (e.g. THD, THD+N, DFD, each with Post FFT) to the selected value
with the goal of increasing measurement speed.
Configure Analog Analyzer