Instrument Functions
R&S
®
UPP
297
User Manual 1411.1055.32 ─ 10
Phase File
Entry of file name for the phase sweep list. Only visible with generator list sweep acti-
vated. Reference
Remote command:
5.9.7
Behavior after Sweep End
The behavior after sweep end determines which signal the generator outputs after a
completed sweep or if the generator is muted.
Halt
After a completed sweep, the generator outputs a signal to be determined by the user
or is muted.
"Start"
After a completed sweep, the generator is set as follows:
●
For "Sweep Ctrl" = "Auto Sweep": As specified in the "Start"
parameter field above this.
●
For "Sweep Ctrl" = "Auto List": As specified in the first entry of the
sweep list.
"Value "
After a completed sweep, the generator is set to the value specified in
the following parameter field. This value can be
outside
of the values
defined by "Start" and "Stop" or outside of the first and last entries of
the sweep list.
"Mute"
After a completed sweep
, the generator level is set to 0 V or 0 FS.
The next sweep cycle eliminates the mute and begins again with the
"Start "value or the first entry of the sweep list.
With running sweep
, the generator is immediately muted, the sweep
is restarted, and the generator is implicitly switched on again.
Remote command:
Halt value
If the parameter field above it is set to "Halt " = "Value " after a completed sweep, the
generator is set to the value specified here. This value can be
outside
of the values
defined by "Start" and "Stop" or outside the first and last entries of the sweep list.
Sweeps
Summary of Contents for R&S UPP
Page 1: ...R S UPP Audio Analyzer User Manual User Manual Version 10 1411105532 ÅP ...
Page 34: ...Contents R S UPP 18 User Manual 1411 1055 32 10 ...
Page 630: ...Instrument Functions R S UPP 614 User Manual 1411 1055 32 10 Format ...
Page 631: ...Instrument Functions R S UPP 615 User Manual 1411 1055 32 10 Format ...
