Rohde & Schwarz R&S UPP, User Manual

Page: 222 / 938

Instrument Functions
R&S
®
UPP
206 User Manual 1411.1055.32 ─ 10
"Multi" This option is offered only if the
●
option R&S UPP-B4 (HDMI and digital audio interfaces) for the 8-
channel "Digital Audio" generation is installed.
●
option R&S UPP-B8 (multichannel audio generator) is installed.
"Multi" enables free selection of up to 8 channels in the following
parameter fields; with the "Universal" generator function, the signals
can be set individually for each channel.
Remote command:
OUTPut:CHANnel
on page 690
Gen Channels
Setting of the respectively active generator channel.
The free configuration of up to 8 channels is offered if the option R&S UPP-B4 (HDMI
and digital audio interfaces) has been installed for 8-channel "Digital Audio" generation
or the option R&S
UPP-B8 (multichannel audio generator) is installed and "Multi" has
been selected.
The corresponding generator channel is switched on or off.
Remote command:
OUTPut:MCHannels<n2>
on page 693
Sync To
Used to select the source to which the digital audio generator is synchronized.
Only available with R&S UPP-B2 (digital audio interfaces).
"Internal CLK" The generator is synchronized to the internal clock generator.
The generator sample rate is determined by the set sample fre-
quency.
"Audio In" Synchronizes to a digital audio signal at the "Digital In" BNC jack.
The generator runs at the same sampling rate as the supplied signal.
Configuring the Digital Generator