Rohde & Schwarz R&S UPP, User Manual

Page: 196 / 938

Manual Operation
R&S
®
UPP
180 User Manual 1411.1055.32 ─ 10
4.15 File Management
The R&S UPP uses files to store all instrument data, i.e. system and user data. User
data includes stored instrument settings, data for equalizer files, lists for sweeps, and
so on.
The files are stored on the instrument's hard disk. The
D:\
drive is available for storing
user-defined data and can have any number of directory structures. A number of
default directories are preconfigured; they can, however, be changed at any time.
Files can be transferred either using a USB stick or via a connected network.
In the case of a connected network, all network drives that can be accessed are availa-
ble (see
Chapter 2.10.2.4, "Accessing directories in the network" , on page 51).
The files are distinguished by their extension; each file type has a certain content. Nor-
mally, the extension is of no importance to the user since the files are accessed in the
associated panels where only the relevant file type is available. For example, the files
with equalizer settings can only be loaded in the "Generator
Function" and "Ana-
lyzer Function" panels if the appropriate function settings have been made.
To load settings or to store results, the "File Select" window must be called up in the
associated panel using the ••• button.
4.15.1 Loading and Saving Instrument Settings
With the menu bar and the button "File", "Load Setup", "Load Example Setup", "Save
Setup as", "Save Setup" or "Load Display Plug-in", the "File
Select" window is called
up.
Every R&S UPP audio analyzer has a range of instrument settings which have been
prepared by Rohde & Schwarz for a broad selection of typical measurements and
which are available on the instrument as sample setups. These setups are divided into
different application areas (AA, AD, DD, DA), depending on whether generator or ana-
lyzer is operated with analog or digital interfaces, and are selected via the menu bar,
"File" and "Load Example Setup".
This allows users to make settings for their own specific measurement tasks very sim-
ply by modifying these example setups.
All of these sample settings are located in the directory D:\UPV\Setup Examples.
Every R&S UPP also features the factory-based default instrument setting which can
be called up directly via the menu bar, "File", "Preset (Load Default)".
File Management