Rohde & Schwarz R&S RTB2000, User Manual, Page: 316 / 609

Remote control commands
R&S
®
RTB2000
316 User Manual 1333.1611.02 ─ 11
Parameters:
<Scale> Scale value, given in Volts per division.
Range:
1e-3 to 10 (without probe attenuation)
*RST: 5e-3
Default unit: V/div
Manual operation: See "[Scale]" on page 57
See "Vertical Scale" on page 61
CHANnel<m>:RANGe <Range>
Sets the voltage range across the all vertical divisions of the diagram. Use the com-
mand alternatively instead of
CHANnel<m>:SCALe
.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<Range> Voltage range value
Range:
8e-3 to 80 (without probe attenuation)
*RST: 40e-3
Default unit: V
CHANnel<m>:POSition <Position>
Sets the vertical position of the waveform in divisions. While the offset sets a voltage,
position is a graphical setting given in divisions.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<Position> Graphical position
Range:
-5 to 5
*RST: 0
Default unit: div
Manual operation: See "[Offset/Position (upper knob)]" on page 57
See "Position" on page 61
CHANnel<m>:OFFSet <Offset>
Sets the offset voltage, which is subtracted to correct an offset-affected signal.
Waveform setup