Rohde & Schwarz R&S RTB2000, User Manual

Page: 131 / 609

Measurements
R&S
®
RTB2000
131 User Manual 1333.1611.02 ─ 11
Quick measurement is not available on math and reference waveforms. Channels
other than the selected one are switched off in quick measurement mode. When quick
measurement is active, cursor measurements are not possible, but you can use auto-
matic measurements in parallel.
► Press the [QuickMeas] key again to deactivate quick measurement.
The results are deleted on the display.
Remote commands:
●
MEASurement<m>:AON
on page 382
●
MEASurement<m>:AOFF
on page 382
●
MEASurement<m>:ALL[:STATe]
on page 382
●
MEASurement<m>:ARESult?
on page 382
7.2 Automatic measurements
You can perform up to 6 different measurements simultaneously.
To configure automatic measurements in the Measure menu
1. Press the [Meas] key.
2. In the menu, select the "Meas. Place", the number of the measurement that you
want to configure.
3. If the measurement is off, enable "Measure <n>".
4. Select the measurement type:
a) Tap "Type"
b) Select the tab of the required measurement category.
c) Select the measurement type.
The measurement types are described in Chapter 7.2.2, "Measurement types" ,
on page 134.
5. Select the "Source".
The selection list shows all possible sources. If the waveform is not active, it is acti-
vated automatically when selected as measurement source.
6. Some measurement types require additional settings. Scroll down the menu, and
adjust the additional settings if necessary.
See also:
Chapter 7.2.3, "Settings for automatic measurements" , on page 138.
7.2.1 Measurement results
The measurement results are shown in a line below the grid.
Automatic measurements