Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 608 / 796

R&S FSP Remote Control – Description of Commands
STATus Subsystem
6.214 Operating Manual 1164.4556.12 - 06
STATus:OPERation:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:OPERation register from 0 to 1 for the
transitions of the CONDition bit.
Example:
"STAT:OPER:PTR 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: A
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined value. All
PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are detected. All NTRansition parts
are set to 0, i.e. a transition from 1 to 0 in a CONDition bit is not detected. The ENABle part of the
STATus:OPERation and STATus:QUEStionable registers are set to 0, i.e. all events in these registers
are not passed on.
Example:
"STAT:PRES"
Characteristics: *RST value: –
SCPI: conform
Mode: A
STATus:QUEStionable:ACPLimit:CONDition?
This command queries the contents of the CONDition section of the STATus:QUEStionable:ACPLimit
register. Readout does not delete the contents of the CONDition section.
Example:
"STAT:QUES:ACPL:COND?"
Characteristics: *RST value: –
SCPI: device-specific
Mode: A
STATus:QUEStionable:ACPLimit:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus:QUEStionable:ACPLimit register.
The ENABle register selectively enables the individual events of the associated EVENt section for the
summary bit.
Example:
"STAT:QUES:ACPL:ENAB 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: A
STATus:QUEStionable:ACPLimit[:EVENt]?
This command queries the contents of the EVENt section of the STATus:QUEStionable:ACPLimit
register. Readout deletes the contents of the EVENt section.
Example:
"STAT:QUES:ACPL?"
Characteristics: *RST value: –
SCPI: device-specific
Mode: A