Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 532 / 796

R&S FSP Remote Control – Description of Commands
MMEMory Subsystem
6.138 Operating Manual 1164.4556.12 - 06
MMEMory:SELect[:ITEM]:TRACe[:ACTive] ON | OFF
This command adds the active traces to the list of data subsets of a save/recall device setting. Active
traces are all traces whose state is not blank.
Example:
"MMEM:SEL:TRAC ON"
Characteristics: *RST value: OFF, i.e. no traces will be stored
SCPI: device-specific
Mode: A
MMEMory:SELect[:ITEM]:TRANsducer:ALL ON | OFF
This command includes all transducer factors and sets in the list of data subsets of a device setting to
be stored/loaded.
Example:
"MMEM:SEL:TRAN:ALL ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
MMEMory:STORe<1|2>:MARKer <file_name>
This command saves the data of all active markers to a file < file_name >.
Example:
"MMEM:STOR:MARK 'C:\marker.txt'"
’Generates a MARKER.TXT file that contains all data of the active markers in
screen A.
If in screen A two markers are active, the gemerated
MARKER.TXT file includes
the following:
Marker;1;T1
-25.87;dBm
19.920000000;GHz
Delta;2;T1
-21.90;dB
-5.920000000;GHz
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
The command is an event and therefore has no *RST value and no query.
MMEMory:STORe<1|2>:PEAKlist <file_name>
This command stores the content of the marker peak list in ASCII format to the specified file.
Parameter: <file_name> := DOS file name
Example:
"MMEM:STOR:PEAK 'D:\TEST.ASC'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A