Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 530 / 796

R&S FSP Remote Control – Description of Commands
MMEMory Subsystem
6.136 Operating Manual 1164.4556.12 - 06
MMEMory:SELect[:ITEM]:ALL
This command includes all data subsets in the list device settings to be stored/loaded.
Example:
"MMEM:SEL:ALL"
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value.
MMEMory:SELect[:ITEM]:DEFault
This command sets the default list of device settings to be stored/loaded. The latter includes:
• current configuration of general device parameters (general setup)
• current setting of the measurement hardware including markers
• activated limit lines
• user-defined color setting
• configuration for the hardcopy output
• activated transducers
• Tracking generator settings
(only in conjunction with option Tracking Generator B9 or External Generator Control B10)
• Correction data for source calibration
(only in conjunction with option Tracking Generator B9 or External Generator Control B10)
Trace data, non-used transucers factors and non-used limit lines are not included.
Example:
"MMEM:SEL:DEF"
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value.
MMEMory:SELect[:ITEM]:HWSettings ON | OFF
This command includes the hardware settings in the list of data subsets of a device setting to be stored/
loaded. The hardware settings include:
• current configuration of general device parameters (general setup)
• current setting of the measurement hardware including markers
• activated limit lines:
A data set may include 8 limit lines at maximum in each measurement window. This number
includes the activated limit lines and, if available, the de-activated limit lines last used.
Therefore the combination of the non-activated restored limit lines depends on the sequence of use
with the command
MMEM:LOAD
.
• user-defined color setting
• configuration for the hardcopy output