Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 490 / 796

R&S FSP Remote Control – Description of Commands
CALCulate Subsystem
6.96 Operating Manual 1164.4556.12 - 06
CALCulate<1|2>:STATistics:SCALe:X:RLEVel -130dBm to 30dBm
This command defines the reference level for the x-axis of the measurement diagram. The setting is
identical to the reference level setting using the command
DISPlay:WINDow:TRACe:Y:RLEVel
.
With the reference level offset <> 0 the indicated value range of the reference level is modified by the
offset.
The unit depends on the setting performed with
CALC:UNIT
.
Example:
"CALC:STAT:SCAL:X:RLEV -60dBm"
Characteristics: *RST value: -20dBm
SCPI: device-specific
Mode: A
CALCulate<1|2>:STATistics:SCALe:Y:LOWer 1E-9 to 0.1
This command defines the lower limit for the y-axis of the diagram in statistical measurements. Since
probabilities are specified on the y-axis, the entered numerical values are dimensionless.
Example:
"CALC:STAT:SCAL:Y:LOW 0.001"
Characteristics: *RST value: 1E-6
SCPI: device-specific
Mode: A
CALCulate<1|2>:STATistics:SCALe:Y:UNIT PCT | ABS
This command toggles the scaling of y-axis between percentage and absolute.
Example:
"CALC:STAT:SCAL:Y:UNIT PCT"
'toggle to percentage
Characteristics: *RST value: ABS
SCPI: device-specific
Mode: A
CALCulate<1|2>:STATistics:SCALe:Y:UPPer 1E-8 to 1.0
This command defines the upper limit for the y-axis of the diagram in statistical measurements. Since
probabilities are specified on the y-axis, the entered numerical values are dimensionless.
Example:
"CALC:STAT:Y:UPP 0.01"
Characteristics: *RST value: 1.0
SCPI: device-specific
Mode: A