Rohde & Schwarz R&S FSP Series, Operating Manual

Page: 412 / 796

R&S FSP Remote Control – Description of Commands
CALCulate Subsystem
6.18 Operating Manual 1164.4556.12 - 06
CALCulate<1|2>:DELTamarker<1...4>:MAXimum:RIGHt
This command positions the specified delta marker to the next smaller maximum value to the right of
the current value (i.e. ascending X values). The corresponding delta marker is activated first, if
necessary.
Example:
"CALC2:DELT:MAX:RIGH"
'Sets delta marker 1 in screen B to the next smaller maximum value to the right of
the current value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate<1|2>:DELTamarker<1...4>:MINimum:LEFT
This command positions the specified delta marker to the next higher minimum value to the left of the
current value (i.e. descending X values). The corresponding delta marker will be activated first, if
necessary.
Example:
"CALC:DELT:MIN:LEFT"
'Sets delta marker 1 in screen A to the next higher minimum to the left of the current
value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate<1|2>:DELTamarker<1...4>:MINimum:NEXT
This command positions the specified delta marker to the next higher minimum value of the trace. The
corresponding delta marker will be activated first, if necessary.
Example:
"CALC1:DELT2:MIN:NEXT"
'Sets delta marker 2 in screen A to the next higher minimum value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate<1|2>:DELTamarker<1...4>:MINimum[:PEAK]
This command positions the specified delta marker to the current minimum value of the trace. The
corresponding delta marker will be activated first, if necessary.
Example:
"CALC2:DELT3:MIN"
'Sets delta marker 3 in screen B to the minimum value of the associated trace.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.