Preparing for Use
R&S
®
FPS
25
Getting Started 1319.3362.02 ─ 07
To perform a self test via Remote Desktop
Performing a self alignment via Remote Desktop requires a controller PC to be
connected, see
Chapter 5.6, "How to Set Up Remote Desktop"
1. Select the SETUP key in the soft front panel on the Remote Desktop.
2. Select the "Service" softkey.
3. Switch to the "Selftest" tab in the "Service" dialog box.
4. Select the "Start Selftest" button.
Once the instrument modules have been checked successfully, a message is
displayed.
2.5
Checking the Supplied Options
The instrument may be equipped with both hardware and firmware options. In
order to check whether the installed options correspond to the options indicated
on the delivery note, proceed as follows.
Checking the supplied options via Remote Desktop requires a controller pc or an
external monitor, mouse and keyboard to be connected, see
1. Select the SETUP key in the soft front panel on the Remote Desktop.
2. Select the "System Config" softkey.
3. Switch to the "Ve Options" tab in the "System Configuration" dialog
box.
A list with hardware and firmware information is displayed.
4. Check the availability of the hardware options as indicated in the delivery
note.
2.6
Protecting Data Using the Secure User Mode
During normal operation, the R&S
FPS uses a solid-state drive to store its operat-
ing system, instrument firmware, instrument self-alignment data, and any user
Protecting Data Using the Secure User Mode
Summary of Contents for R&S FPS
Page 25: ......
