Remote Commands
R&S
®
Spectrum Rider FPH
306
User Manual 1321.1011.02 ─ 06.00
CALCulate<1...2>:MATH<1...2>:STATe
<State>
This command turns trace mathematics on and off.
The numeric suffix at CALCulate and MATH are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:MATH:STAT ON
Switches on the trace mathematics.
DISPlay<1...2>[:WINDow]:TRACe<1...2>[:STATe]
<State>
This command turns a trace on and off.
The numeric suffix at DISPlay and TRACe are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
ON for TRACe1, OFF for TRACe2
Example:
DISP:TRAC2 ON
Turns on the trace 2.
DISPlay<1...2>[:WINDow]:TRACe<1...2>:MEMory[:STATe]
<State>
This command turns the memory trace on and off.
The numeric suffix at DISPlay and TRACe are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
DISP:TRAC:MEM ON
Activates the memory trace.
DISPlay<1...2>[:WINDow]:TRACe<1...2>:MODE
<DisplayMode>
This command selects the trace mode.
If you are using the average, max hold or min hold trace mode, you can set the number
of measurements with
[SENSe:]SWEep:COUNt<SweepCount>
. Note that synchroni-
zation to the end of the average count is possible only in single sweep mode.
The numeric suffix at DISPlay and TRACe are irrelevant for this command.
Remote Control - Commands
