NB-IoT Signaling
R&S
®
CMW-KM300/-KS300
64
User Manual 1178.5689.02 ─ 06
Figure 2-34: Neighbor cell settings
To configure the neighbor cell entries, press the "Edit" button.
Figure 2-35: Neighbor cell list configuration dialog
Only the enabled entries are broadcast.
The individual neighbor cell settings are described in the following.
NB-IoT
For an NB-IoT neighbor cell entry, you can specify the operating band and downlink
channel number, the physical layer cell ID and the "QOffset".
Parameter "QOffset" corresponds to the value "q-OffsetCell" in 3GPP TS 36.331,
which equals "Qoffset
s,n
" in 3GPP TS 36.304. It is used by the UE when evaluating
candidates for cell reselection or triggering conditions for measurement reporting.
If the channel number of an entry and the currently used channel number are identical,
the parameters are written into system information block 4 (intra-frequency cell rese-
lection). Otherwise they are written into system information block 5 (inter-frequency cell
reselection).
The list supports up to 16 active neighbor cell entries. The active entries can use up to
five different channel numbers. Active entries with the same channel number must
have different cell IDs.
Remote command:
CONFigure:NIOT:SIGN<i>:NCELl:NIOT:CELL<n>
2.3.10.2
Cell Reselection Settings
Access: "Config" hotkey > "Network" > "Cell Reselection" section.
The parameters in this section define cell reselection information to be transmitted in
the system information blocks SIB1 and SIB3. For detailed information, refer to 3GPP
TS 36.304 and 3GPP TS 36.331.
GUI Reference
深圳德标仪器
135-1095-0799