Rohde & Schwarz R&S CMW-KM300, User Manual, Page: 125 / 388

NB-IoT Signaling
R&S
®
CMW-KM300/-KS300
125 User Manual 1178.5689.02 ─ 06
Active scenario
SCEL : "Standard Cell"
SCF : "Standard Cell - Fading"
TROF : "1CC - Fading - 2x1"
<RXConnector> RF connector for the input path
<RXConverter> RX module for the input path
<TXConnector> RF connector for the output path
<TXConverter> TX module for the output path
<Fader> Internal fader, only returned for fading scenarios
Usage: Query only
Firmware/Software: V3.7.20, V3.7.60: <Scenario> SCF, TROF and <Fader>
ROUTe:NIOT:SIGN<i>:SCENario[:FLEXible]:SCELl <BBBoard>, <RXConnector>,
<RXConverter>, <TXConnector>, <TXConverter>
Activates the scenario "Standard Cell" and selects the signal paths.
For possible parameter values, see Chapter 2.5.1.2, "Values for Signal Path Selection" ,
on page 105.
Parameters:
<BBBoard> Signaling unit
<RXConnector> RF connector for the input path
<RXConverter> RX module for the input path
<TXConnector> RF connector for the output path
<TXConverter> TX module for the output path
Example: See Chapter 2.4.1.2, "Configuring the Signal Paths" , on page 94
Firmware/Software: V3.7.20
Manual operation: See "Scenario" on page 44
ROUTe:NIOT:SIGN<i>:SCENario:SCFading[:FLEXible]:INTernal <PCCBBBoard>,
<RXConnector>, <RXConverter>, <TXConnector>, <TXConverter>,
<PCCFadingBoard>
Activates the scenario "Standard Cell Fading" and selects the signal paths.
For possible parameter values, see Chapter 2.5.1.2, "Values for Signal Path Selection" ,
on page 105.
Parameters:
<PCCBBBoard> Signaling unit
<RXConnector> RF connector for the input path
<RXConverter> RX module for the input path
Command Reference
深圳德标仪器
135-1095-0799